The threaded lock ring on the elbow plug from the spring cord from my handset has stripped threads. The previous owner must have tried tightening it too tight with pliers. As a result my connection…Continue
"Welcome to the Raymarine Technical Forum Tom,
Please excuse this late response. The part number for the Ray240 handset cord is R49144.
Raymarine parts may be ordered from an authorized Raymarine dealer or from Raymarine Order Services…"
The threaded lock ring on the elbow plug from the spring cord from my handset has stripped threads. The previous owner must have tried tightening it too tight with pliers. As a result my connection is not consistent.May I buy a new cord from Raymarine to install myself? Or must send the handset in for your repair dept. to install?Tom ArnoldCincinnati, Ohio2011 Sea Ray 310 SundancerSee More
Thia may be a bit late,but I'll try.
I just installed the eS78 MFD with the Quantum (wireless) radar, which I want to use with my existing ST60 series instruments. With my old radar, they interfaced fine, but with the new…"
"I can give you very little help here. After jerking around with the connection for months I finally decided to skip it. The Standard Horizon, which works beautifully despite the small screen is below and required leaving the helm to read.
"I am purchasing a Standard Horizon gx2200 vhf with GPS and AIS. I currently have a C80 MFD. On the back of the mfd the NMEA IN/OUT connection is available.
Using a RO8004 cable with the appropriate connection on one end can I join up the C80 at the…"
"All I can say is try getting your position by using the white wire!
I know Ariel Cheng, she is just a temp. She doesn't know how to distinguish one wire from another.
I used to deal with Evermore and found their receivers to be poor, thin wires…"
"Evermore ( Mrs Ariel Cheng ) answered me Today:
Red wire: VCC power (+12V)
Green wire: Tx, Output signal
White wire: Rx, imput signal
Black wire: Ground
Gray wire: Shield wire, signal ground
Blue wire: Not used
I did not think anyone…"
"I just installed my new Dragonfly 7 pro when I power it up the Dragonfly emblem comes up it then blinks goes to a blank screen with a blinking in the upper left hand corner then it goes back to the Raymarine emblem sometimes it goes to the accept…"