Jan-Erik
  • Male
  • Eugene, MO
  • United States
Share
  • Blog Posts
  • Discussions (9)
  • Events
  • Photos
  • Photo Albums
  • Videos

Jan-Erik's Discussions

Alarms in LightHouse II

Started this discussion. Last reply by Moderator - Raymarine, US Jul 24, 2014. 1 Reply

HelloIs there a possibility to deactivate the following alarms:1. Low voltage alarm. This triggers in the c95 unit when we use the bow thruster.2. Waypoint arrival alarm. I want to activate the route…Continue

Feature requests

Started this discussion. Last reply by Moderator - Raymarine, US May 19, 2014. 1 Reply

HelloWe are using c95 with the latest software version (10.34). Is there the following functionality and if not, could it be added?1. In chart view using heading up the boat is in the middle of the…Continue

Islands disappear when zooming out on c95/Navionics Gold

Started this discussion. Last reply by Moderator - Raymarine, US Apr 11, 2014. 3 Replies

HelloI noticed that islands disappear when zooming out. This is very dangerous in my mind. How is this possible?Also very hard to take the correct heading if the islands farther away do not display…Continue

New boat with all Raymarine electronics

Started this discussion. Last reply by Jan-Erik Jun 29. 8 Replies

HelloI'm about to install new electronics to a 26 foot boat with Volvo D4-260A-B stern drive (DPH-A) diesel engine. The boat is model year 2006 and has Raymarine C80/GPS125 and ST30 bidata installed.…Continue

Gifts Received

Gift

Jan-Erik has not received any gifts yet

Give a Gift

 

Jan-Erik's Page

Latest Activity

Jan-Erik replied to Jan-Erik's discussion New boat with all Raymarine electronics
Jun 29
Jan-Erik updated their profile
Apr 24, 2015
Moderator - Raymarine, US replied to Jan-Erik's discussion Alarms in LightHouse II
"Welcome to the Raymarine Technical Forum Jan-Erik, Q1. Low voltage alarm. This triggers in the c95 unit when we use the bow thruster. A1. This condition represents a fault within the MFD's installation.  Please click here to view…"
Jul 24, 2014
Jan-Erik posted a discussion

Alarms in LightHouse II

HelloIs there a possibility to deactivate the following alarms:1. Low voltage alarm. This triggers in the c95 unit when we use the bow thruster.2. Waypoint arrival alarm. I want to activate the route to see how far we have to go and ETA, etc. but I do not need to receive waypoint alarms. I know where I'm at and when I need to turn.(c95 is running v10.41)Small feature request: please add volume per distance (l/nm) to the fuel options. Currently there exists distance per volume option…See More
Jul 24, 2014
Moderator - Raymarine, US replied to Jan-Erik's discussion Feature requests
"Welcome to the Raymarine Technical Forum Jan-Erik, Q1. In chart view using heading up the boat is in the middle of the screen. Is it possible to place the boat icon at the bottom? We are interested in where we are going and not where we have…"
May 19, 2014
Jan-Erik posted a discussion

Feature requests

HelloWe are using c95 with the latest software version (10.34). Is there the following functionality and if not, could it be added?1. In chart view using heading up the boat is in the middle of the screen. Is it possible to place the boat icon at the bottom? We are interested in where we are going and not where we have been.2. Changing the active screen in split screen mode requires pressing the switch button and then to rotate the "joystick". Wouldn't it be better to just press the change…See More
May 17, 2014
Underway - Raymarine, US replied to Jan-Erik's discussion Temperature from Airmar to NMEA2000?
"No, because most of the instruments that do Speed and Temperature will require a Speed connection as well."
Apr 22, 2014
Moderator - Raymarine, US replied to Jan-Erik's discussion Islands disappear when zooming out on c95/Navionics Gold
"Jan,  By default, the MFD's EasyView feature is configured to OFF.  You can verify this yourself by performing a Factory Reset operation and then checking the state of this feature. Raymarine's a/c/e/gS-Series MFDs and Dragonfly…"
Apr 11, 2014
Jan-Erik replied to Jan-Erik's discussion Islands disappear when zooming out on c95/Navionics Gold
"Thank you for the quick response. EasyView was the issue and now it is displaying as it should. In my opinnion the default should be OFF. Is it possible to use other maps (C-MAP?) than Navionics on the c95? We are not happy with the…"
Apr 11, 2014
Moderator - Raymarine, US replied to Jan-Erik's discussion Islands disappear when zooming out on c95/Navionics Gold
"Welcome to the Raymarine Technical Forum Jan-Erik, It is recommended that you verify that the Chart application's EasyView feature has been configured to OFF.  If so, and the problem persists, then it is recommended that your MFD be…"
Apr 10, 2014
Jan-Erik posted a discussion

Islands disappear when zooming out on c95/Navionics Gold

HelloI noticed that islands disappear when zooming out. This is very dangerous in my mind. How is this possible?Also very hard to take the correct heading if the islands farther away do not display on the map.MFD is c95 with newest firmware and map is Navionics Gold (updated content 1 month ago).Regards,Jan-ErikSee More
Apr 10, 2014
NKO, Raymarine, US replied to Jan-Erik's discussion New boat with all Raymarine electronics
"The ACU-200 requires the EV-1 core sensor. The only Evolution autopilot that utilizes the EV-2 core sensor is the EV-DBW."
Jan 31, 2014
Jan-Erik replied to Jan-Erik's discussion New boat with all Raymarine electronics
"I understand and I will ask Volvo, but the question I had was can EV-2 send instructions to ACU-200 or does it have to be an EV-1?"
Jan 31, 2014
NKO, Raymarine, US replied to Jan-Erik's discussion New boat with all Raymarine electronics
"Janne,  I would contact your local Volvo Penta dealer and find out exactly what system you have and the specific's of your Volvo Penta steering system. I do not know the meaning of A, B, C, E etc.. extensions."
Jan 31, 2014
Jan-Erik replied to Jan-Erik's discussion New boat with all Raymarine electronics
"Ok, I think i get it now. We hace EVC-C, not EVC-E. The latter has also steering with DBW, EVC-C does not. So what about using ACU-200 with EV-2, is it possible?"
Jan 31, 2014
NKO, Raymarine, US replied to Jan-Erik's discussion New boat with all Raymarine electronics
"Hi Janne,  In regards to the Raymarine autopilot in conjunction with Volvo Penta's EVC platform, it is a driven by wire system. Thus the recommendation for the EV-DBW Raymarine Part# T70164  EVC -…"
Jan 30, 2014

Profile Information

Models of Raymarine Product(s) Owned or Considering
MFD c95, RD418D Radar, ECI-100

Comment Wall

You need to be a member of Raymarine Technical Forum to add comments!

  • No comments yet!
 
 
 

Events

Videos

  • Add Videos
  • View All

Photos

  • Add Photos
  • View All

Latest Activity

Gregory S******* updated their profile
Saturday
Folkmeister replied to Mikael H's discussion Show vessels name from AIS
"Reactivating this old thread -   My prior boat had an e7 and AIS650 which worked great, vessel names were displayed with target info.  My new boat has older e80 and e120 plotters.  We have just installed AIS, but the vast majority of…"
Friday
Carol Shores updated their profile
Aug 8
Jorge Chubretovich updated their profile
Aug 3
J&G Marine supply replied to Don Gulliver's discussion AIS recommissioning
"Where on the web is the procedure to reset the mmsi.  Iknow pro ais to program but how do you clear the old mmsi"
Jul 17
Richard Gard liked Tom MacAllister's discussion E80 Issues
Jul 17
Richard Gard liked Miguel Gonzalez del Rey's discussion E120 -E80
Jul 17
Richard Gard replied to Adam Hyde's discussion New C125 won't display NMEA 0183 depth data
"subscribed"
Jul 17
Richard Gard liked Adam Hyde's discussion New C125 won't display NMEA 0183 depth data
Jul 17
TJ replied to Gerhard Lang's discussion CompactFlash card for E120/E80 classic series, data exchange waypoints and routes
"FAT 32 or 16 the compatibility tool is gone now."
Jul 13
Tim Turner replied to Tim Turner's discussion ST60+ Wind
"will that transducer work with a st50?"
Jul 2
Jan-Erik replied to Jan-Erik's discussion New boat with all Raymarine electronics
Jun 29
Tony O replied to Brad's discussion Rejoining cut Raynet cable for radar
"My radar  stopped working and I found a small Nick in my cable. Seeing that I could not get access to the place where the cable was run, I decided to open the cable to see how many wires were cut. Luckily there was only one so I Soldered them…"
Jun 25
Jindrich Dokonal replied to Robert Dahn's discussion ST70 Plus Power Cable
"Hi, How can I purchase a power cable for my ST70+plus display? Best regards, Henry"
Jun 25
Tom replied to Tom's discussion Pink "jelly fish" like icon meaning on chart
"I returned and got a picture. What does it mean?https://i.imgur.com/Du4JdEL.jpg"
Jun 19
Lasse Åhlander updated their profile
Jun 16

© 2018   Created by Moderator - Raymarine, US.   Powered by

Badges  |  Report an Issue  |  Terms of Service