Gary Corkran
  • Male
  • Joppa, MD
  • United States
Share Twitter
  • Blog Posts
  • Discussions (1)
  • Events
  • Photos
  • Photo Albums
  • Videos

Gary Corkran's Discussions

Raymarine SL70 Pathfinder

Started this discussion. Last reply by NKO, Raymarine, US Aug 1, 2012. 1 Reply

Hello,I have a Raymarine SL70 Pathfinder.  Everything is hooked up correctly as I have not had any problems with my system the past few years.  However a few weeks ago, one of the copper prongs pull…Continue

Tags: Pathfinder, Sl70

 

Gary Corkran's Page

Gifts Received

Gift

Gary Corkran has not received any gifts yet

Give Gary Corkran a Gift

Comment Wall

You need to be a member of Raymarine Technical Forum to add comments!

Join Raymarine Technical Forum

  • No comments yet!
 
 
 

Events

Videos

  • Add Videos
  • View All

Photos

Loading…
  • Add Photos
  • View All

Latest Activity

Moderator - Raymarine, US replied to Peter Hinton's discussion E-80 boot failure
"Peter, Unfortunately, it would only be possible to further diagnose the failure through inspection of the MFD.  The flat rates for repairs may be found here."
3 hours ago
Profile IconMrbill419, Kenneth M Church, Karen S and 10 more joined Raymarine Technical Forum
4 hours ago
paul replied to William Coohon's discussion i70 v2.17
"Hi Will, Apologies, my question should have been directed to Raymarine. Regards, Paul"
5 hours ago
Peter Hinton replied to Peter Hinton's discussion E-80 boot failure
"The second unit works fine with the same power cord on both the fly bridge and the main helm. The master unit fails at both locations. The power (voltage) is 13.8 volts. Any idea what kind of repair will be necessary? Is it expensive? Is it worth…"
6 hours ago
alejandro Zarich replied to alejandro Zarich's discussion i60 close haul working randomly
"All plugs are wher they should be..the blacks in the White unused ends and the blue in the blue unused seatalk ng ends, The i70 has a black plug as it is the end of the daisy chain. This said, I was able to upgrade the i60 sw, beneffiting from a…"
6 hours ago
Keiith replied to Keiith's discussion EV 200 power
"Thanks for the guidance, I will follow it next week end. not going to boat this week end I have another question,my ACC powers the seatalk network. I also have a garmin 740s which I connected into the seatalk network with a devicenet-seatalk…"
7 hours ago
André Cavallari replied to André Cavallari's discussion Autohelm2000
"My pilot is autohelm2000 , Not st2000. Then autohelm2000 works????"
8 hours ago
William Coohon replied to William Coohon's discussion i70 v2.17
"??? Seems to be working for me. No indication of what was wrong. Boat just put up for winter so can wait."
9 hours ago
Moderator - Raymarine, US replied to Rick Bell's discussion NO GPS on RAY55 from AIS650
"Rick, It is generally not recommended that on use the GPS output of the AIS650 for such purposes.   Should the Output GNSS sentences be configured ON, then these sentences will be transmitted along with AIS data via the AIS650's 38400 BAUD…"
9 hours ago
Rick Bell replied to Rick Bell's discussion NO GPS on RAY55 from AIS650
"I do not want the bridged GPS data from the E127.  Are you saying then that I can not use the GPS from the AIS as the input to the VHF?  Documentation seems to suggest you can. The E127 is nowhere near the AIS and VHF and will be difficult…"
10 hours ago
Moderator - Raymarine, US replied to Peter Hinton's discussion E-80 boot failure
"Welcome to the Raymarine Technical Forum Peter, It is recommended that the problematic MFD's power cable be unplugged and that the loaded system voltage be measured to ensure that it is within the operating range of the MFD (10.7-32.0 VDC).…"
10 hours ago
Peter Hinton posted a discussion

E-80 boot failure

I have 2 e-80 chartplotters that were working fine. Now the Master unit is expereincing issues booting up. When the power plug is connected, the unit starts to boot, about 2-3 seconds, then it goes black, then starts up again. It never gets the the splash screen and will stay in this loop until the power plug is removed. Factory reset does not work as it never boots into the unit far enough to start. I have disconnected all cables, and then connected only the power plug, but it made no…See More
10 hours ago
Harry Keith replied to Graham Stephen's discussion Updating firmware on SeaTalk/SeaTalkNG Converter, i70 and ST70
"Paul, Amen brother!  While the iI70 is a sweet piece of gear, I'm going to pull the trigger on two B&G Triton's this month because they sell a $100 dongle -- and are working to bring an Actisense solution to the table. I have…"
11 hours ago
Paul replied to Graham Stephen's discussion Updating firmware on SeaTalk/SeaTalkNG Converter, i70 and ST70
"OK, well it has been well over a year since the original question came up.  Has a way been found to update the firmware on the i70 from a PC?  Like the original poster I have i70 displays as cockpit instruments and an Actisence gateway…"
11 hours ago
Moderator - Raymarine, US replied to roddy henderson's discussion E-80 MFD white screen, after lightning nearby
"Roddy, You may want to try the Factory Reset procedure found here.  However, I suspect that it's going to need to be repaired."
11 hours ago
Peter Hinton replied to roddy henderson's discussion E-80 MFD white screen, after lightning nearby
" I have a very similar problem. Just plugging the power plug in starts the cycle and it continues until the power plug is removed.   Did you find resolution to your problem?   Peter"
11 hours ago

© 2014   Created by Moderator - Raymarine, US.   Powered by

Badges  |  Report an Issue  |  Terms of Service