I have a new Dragonfly model E7008 which I just installed on a small Keywest 176I loose bottom lock at speeds above 5 mph. I have tried several different locations for the transducer. I setup an…Continue
The mount of the Dragronfly/CP100 transom mounted transducers features lash ... this is normal, and will permit the trailing end of the transducer to have as much as 1/2" of vertical play. When operating in CHIRP mode, bottom should…"
"It is very difficult to take the pictures you have requested since the boat is in the water. I have never had this issue before with either thru hull or transom mounted transducers, is there something that that makes this xducer very sensitive ?…"
"Welcome to the Raymarine Technical Forum Fred,
Please add some digital photos to the discussion showing the transom of the vessel, underside of the hull (looking forward from the transom, and a side profile of the transducer mounted on the transom."
I have a new Dragonfly model E7008 which I just installed on a small Keywest 176I loose bottom lock at speeds above 5 mph. I have tried several different locations for the transducer. I setup an arrangement using a 1x3 by 4ft extension which allows me to move the transducer without drilling new holes each time. I even tried clamping it on the side , well away from the motor etc. That didn't help, same results.Ant thoughts would be appreciated.Fred Lighthouse Point, Fl.See More
"Hi, I´m having problems with, apparently; the compass. I did the tests you suggested and my readings were 6 and 6.1 instead of 4 ohms, and 9.6 or so instead of 8 ohms, all the rest open as you mentioned. May I assume that the compass is…"
"Good day and happy new year to this forum group.
Question: When can we expect Raymarine to ad a night color palette to its line of MFDs? It’s been talked about in this forum for at least 3 years.
I am 100% satisfied with…"
Please read the moderator's instructions on April 8, 2013 and my posting on October 31, 2013 on page 1 of this discussion.
The issue has to do with the Plotter Mode setting. The Plotter Mode must be OFF for all…"
I also have a Rl80 with the old chip and has worked perfect without any updates except last month it performed exactly as you described. The maps I have always used now say no Data. I was going to buy a new chip, but not…"