Brad Martinsen
  • Male
  • Georgetown
  • Cayman Islands
Share
  • Blog Posts
  • Discussions (4)
  • Events
  • Photos
  • Photo Albums
  • Videos

Brad Martinsen's Discussions

E7D Resets time zone to +2UTZ once a weekby itself? We are in -5UTZ

Started this discussion. Last reply by Moderator - Raymarine, US Apr 1, 2015. 5 Replies

MY new E7D Resets time zone to +2GMT once a week by itself(Sundays)?  We are in -5GMTI change it back when I notice usually once a week, I believe it is happening on Sundays. It is always changing to…Continue

Tags: E7D

Gifts Received

Gift

Brad Martinsen has not received any gifts yet

Give a Gift

 

Brad Martinsen's Page

Latest Activity

Brad Martinsen replied to Brian Stinson's discussion i60 Wind Indicator.
"Sure would be nice to have a choice of using SOG or STW. Like I had on my old NAVman Wind that i just replaced with an I60. Hardly use STW were i am."
Jun 4
Moderator - Raymarine, US replied to Brad Martinsen's discussion E7D Resets time zone to +2UTZ once a weekby itself? We are in -5UTZ
"Should the problem persist, then it is recommended that a system diagram of your system listing the make/models of all marine electronics products installed within your system be added to a response to this discussion.  The Diagnostics file for…"
Apr 1, 2015
Brad Martinsen replied to Brad Martinsen's discussion E7D Resets time zone to +2UTZ once a weekby itself? We are in -5UTZ
"Ok it's been a month. I've updated the E7 Firmware and problem still there. Did a Data reset. This seem good for 3 wks, then it happened twice in one week. I had AP control off but once in awhile I'd get a pop-up saying " AP in…"
Mar 31, 2015
Moderator - Raymarine, US replied to Brad Martinsen's discussion E7D Resets time zone to +2UTZ once a weekby itself? We are in -5UTZ
"Noted."
Feb 24, 2015
Brad Martinsen replied to Brad Martinsen's discussion E7D Resets time zone to +2UTZ once a weekby itself? We are in -5UTZ
"I'm currently at V12.26 , downloading latest but it has 2 more hours to go. Also, have a E22158 Seatalk-STNG convertor with V1.21 I've turned off AP control for now. I like beening able to use it to goto way points just dont like large pop…"
Feb 24, 2015
Moderator - Raymarine, US replied to Brad Martinsen's discussion E7D Resets time zone to +2UTZ once a weekby itself? We are in -5UTZ
"Welcome to the Raymarine Technical Forum Brad, The currently installed version of software within the MFD and any device which has been interfaced via RayNet/SeaTallkhs/Ethernet or SeaTalkng/NMEA 2000 communications protocol to the MFD may be…"
Feb 24, 2015
Brad Martinsen posted a discussion

E7D Resets time zone to +2UTZ once a weekby itself? We are in -5UTZ

MY new E7D Resets time zone to +2GMT once a week by itself(Sundays)?  We are in -5GMTI change it back when I notice usually once a week, I believe it is happening on Sundays. It is always changing to +2GMT.This is a bit un-nerving having preferences change on their own, granted this is propably not going to cause harm but is it part of a bigger problem?Also it would be nice if changes in auto-pilot On/standby didn't pop up on MDF and completely cover map that Im veiwing. Can this be turned off.…See More
Feb 24, 2015
Brad Martinsen is now a member of Raymarine Technical Forum
Feb 11, 2015

Profile Information

Models of Raymarine Product(s) Owned or Considering
E7D,ST6002 ST60's

Comment Wall

You need to be a member of Raymarine Technical Forum to add comments!

  • No comments yet!
 
 
 

Events

Videos

  • Add Videos
  • View All

Photos

Loading…
  • Add Photos
  • View All

Latest Activity

Tom Arnold updated their profile
yesterday
Donald Evans replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"All I can say is try getting your position by using the white wire! I know Ariel Cheng, she is just a temp. She doesn't know how to distinguish one wire from another. I used to deal with Evermore and found their receivers to be poor, thin wires…"
Monday
M.Catarall replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"You say Correct it is White wire: Rx, imput signal not data out but data in as shown on reply from Evermore"
Monday
Donald Evans replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"Seems you still don't understand what Cheng is saying."
Monday
M.Catarall replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"Evermore ( Mrs Ariel Cheng ) answered me Today: Hello Lorenzo, Red wire: VCC power (+12V) Green wire: Tx, Output signal White wire: Rx, imput signal Black wire: Ground Gray wire: Shield wire, signal ground Blue wire: Not used I did not think anyone…"
Sunday
Donald Evans replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"You're still wrong. Evermore white wire is not the NMEA data out. And don't call me stupid. Get your facts right before commenting."
Sunday
M.Catarall replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"The information was not wrong when posted. I suggest you look at the date of the post before adding stupid comments"
Sunday
Donald Evans replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"Hahahahaha, you're all totally wrong. Should have bought it from www.gps-galore.co.uk The guy's an expert on these."
Sunday
Brian Kidwell updated their profile
Friday
Ricky Ladd replied to Joel Hjelseth's discussion Raymarine Dragonfly 7 malfunction
"I just installed my new Dragonfly 7 pro when I power it up the Dragonfly emblem comes up it then blinks goes to a blank screen with a blinking in the upper left hand corner then it goes back to the Raymarine emblem sometimes it goes to the accept…"
Aug 8
F John Draeger replied to F John Draeger's discussion Wind transducer data to Corepak 150 autopilot computer with Seatalk to Seatalk ng converter in network
"I am not getting speed information from my Airmar 2039901 transducer to my St50 plus. The reading is 0.0 kn and the transducer is clean. I have checked the connection and it is mechanically good. I have an i50 speed on the mast and I don't get…"
Jul 25
Pablo Luchetti updated their profile
Jul 24
Sophocles Hadjiosif replied to Greg B's discussion Can the P70R be used on a sailboat?
"If you can't auto tack with the p70r then what is the reason that some sailboats elect to install it? Can you program another soft button for tacking?"
Jul 23
David Harwood replied to David Harwood's discussion i50 technical info
"After a multi-year refit, my boat launched last August.  I am now attempting installation of the i50 TriData instrument in stand-alone mode (no network). Connections: 8 discreet connections on lower back of instrument. 1-3 for depth, 4-8 for…"
Jul 22
Gordon Scriba updated their profile
Jul 22
elvira replied to David Poeltl's discussion p70 installation problem
"I have a similar problem.  I have a smartpilot x30 and control head  I have the nmea 0183 connected to my garmin 7000 chartplotter  I receive the fluxgate compass data in my chartplotter, but not the data from my chartplotter in the…"
Jul 15

© 2017   Created by Moderator - Raymarine, US.   Powered by

Badges  |  Report an Issue  |  Terms of Service