Will the new a series network with my E80 classic at the helm?  I want the ability to utilize the a65 at my nav station as a master so I can reduce the power consumption of the E80 while underway and not at the helm.  Thanks!

Views: 69

Reply to This

Replies to This Discussion

Found the answer to my own question.  No compatibility (graphics) between the E80 classic and the new a65.  So...is there a "smaller" unit that I can use as a data and graphic "master" at the chart table that would be compatible with the old E80 classic?

Welcome to the Raymarine Technical Forum Gordon,

Unfortunately, creation of a second station onboard would require that a second E-Series Classic MFD (E80, E120) be intalled onboard and that the additional MFD be interfaced to the currently installed E80 via SeaTalkhs communications.  As the E-Series Classic MFDs have been retired for some time, the best source of such MFDs would be Internet auction sites (ebay, Craigs List, etc.).  Alternatively, the currently installed E80 would need to be replaced with a new c/e-Series MFD (c95, c97, c125, c127, e7, e7D, e95, e97, e125, e127, e165) and an a-Series MFD (a65, a67).

Reply to Discussion

RSS

Events

Videos

  • Add Videos
  • View All

Photos

Loading…
  • Add Photos
  • View All

Latest Activity

Robert Garrett liked Robert Garrett's profile
Sep 13
James Coolbaugh replied to Michael McDonald's discussion Integrating ST60+ instruments to eS78 Chartplotter via Seatalk Conversion Kit
"Greetings, Thia may be a bit late,but I'll try. I just installed the eS78 MFD with the Quantum (wireless) radar, which I want to use with my existing ST60 series instruments. With my old radar, they interfaced fine, but with the new…"
Sep 8
martin schulman replied to martin schulman's discussion nmea connector- C 80 chartplotter to VHF
"I can give you very little help here. After jerking around with the connection for months I finally decided to skip it. The Standard Horizon, which works beautifully despite the small screen is below and required leaving the helm to read.  I…"
Sep 4
Peter Stewart replied to martin schulman's discussion nmea connector- C 80 chartplotter to VHF
"I am purchasing a Standard Horizon gx2200 vhf with GPS and AIS. I currently have a C80 MFD. On the back of the mfd the NMEA IN/OUT connection is available. Using a RO8004 cable with the appropriate connection on one end can I join up the C80 at the…"
Sep 4
COUCHSAILORS.com updated their profile
Aug 24
COUCHSAILORS.com replied to Steve C's discussion ST60+ Tridata Not Calibrating to SOG
"When I press reset to accept the SOG which I am seeing it beeps but still shows 0.0 and doesn't transfer the SOG to the speed. Please advise."
Aug 24
Tom Arnold updated their profile
Aug 22
Donald Evans replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"All I can say is try getting your position by using the white wire! I know Ariel Cheng, she is just a temp. She doesn't know how to distinguish one wire from another. I used to deal with Evermore and found their receivers to be poor, thin wires…"
Aug 21
M.Catarall replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"You say Correct it is White wire: Rx, imput signal not data out but data in as shown on reply from Evermore"
Aug 21
Donald Evans replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"Seems you still don't understand what Cheng is saying."
Aug 21
M.Catarall replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"Evermore ( Mrs Ariel Cheng ) answered me Today: Hello Lorenzo, Red wire: VCC power (+12V) Green wire: Tx, Output signal White wire: Rx, imput signal Black wire: Ground Gray wire: Shield wire, signal ground Blue wire: Not used I did not think anyone…"
Aug 20
Donald Evans replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"You're still wrong. Evermore white wire is not the NMEA data out. And don't call me stupid. Get your facts right before commenting."
Aug 20
M.Catarall replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"The information was not wrong when posted. I suggest you look at the date of the post before adding stupid comments"
Aug 20
Donald Evans replied to Lorenzo Vanni's discussion Raychart BC420 and Evermore SA-320
"Hahahahaha, you're all totally wrong. Should have bought it from www.gps-galore.co.uk The guy's an expert on these."
Aug 20
Brian Kidwell updated their profile
Aug 18
Ricky Ladd replied to Joel Hjelseth's discussion Raymarine Dragonfly 7 malfunction
"I just installed my new Dragonfly 7 pro when I power it up the Dragonfly emblem comes up it then blinks goes to a blank screen with a blinking in the upper left hand corner then it goes back to the Raymarine emblem sometimes it goes to the accept…"
Aug 8

© 2017   Created by Moderator - Raymarine, US.   Powered by

Badges  |  Report an Issue  |  Terms of Service